Saw Stand Assembly - Sawmaster R1040 Owner's Manual

R1040 • Owner's Manual

Saw Stand Assembly

FOLDING STAND
1. It is recommended that adjusting the folding leg be
done by at least two people.
Remove the detachable wheel assembly and stow it
2.
on the frame.
3. Shift the cutting head away from the end of the frame
where the leg is being adjusted. Tighten the cutting
head carriage knob to hold the head in place.
4. Loosen the knob that is locking the leg in place.
5. Lift the saw slightly to give the leg room to rotate into
stow/deployed postion.
Slide the leg in place and tighten the knob.
6.
7. Repeat steps 2-4 as required to the remaining legs.
EASY TRANSPORT
1. It is recommended that adjusting the folding leg be
done by at least two people.
2. Remove the detachable wheel assembly and stow it
on the frame.
Shift the cutting head away from the end of the frame
3.
where the leg is being adjusted. Tighten the cutting
head carriage knob to hold the head in place.
Loosen the knob that is locking the leg in place.
4.
5. Lift the saw slightly to give the leg room to rotate into
stow/deployed postion.
6. Slide the leg in place and tighten the knob.
7. Insert the detachable wheel assembly in either the
frame/leg position depending on need.
8. Make sure the head is on the side closest to the
wheels before transporting the saw.
7