The Cutting Table - Sawmaster R1040 Owner's Manual

R1040 • Owner's Manual

The Cutting Table

FEATURES
• The easily removable cutting table is
covered with an anti-skid rubber coating,
which allows the material being cut to sit on
the table while the cutting head is pulled
through it.
Simply line up the material being cut with
•
the appropriate pre-marked lines on the
cutting table.
STEPS TO MAKE MITER CUTS:
!
The bench saw is equipped with a hinged
1.
guide rail that allows the user to make
accurate miter cuts.
2. To pivot the guide rail, lightly loosen the
knobs at both ends of the saw.
3. Set the rail to the desired angle by using
both hands to firmly hold the rail and
rotating it. While still holding the rail at the
desired angle, tighten each knob.
WARNING:
Turn off the saw before pivoting the guide rail. Do not attempt to
pivot the rail mid-cut. The saw blade must be clear of the material
being cut and the saw must be turned off first!
13