Table of Contents
Advertisement
Water Pump Installation
1.
Remove the water pump from the box and
check that it is not damaged.
2.
Place the water pump into the bracket at the
left front corner of the water tray, as shown
on right.
Position the water outlet of the pump so that
3.
it lays horizontally. Connect the water hose
from the blade guard to the water pump.
Plug the power cord into the 3-prong recep-
4.
tacle coming from the power switch housing.
Overflow Plug Installation
A tube at the rear end of the
saw filters the debris from the
water produced during the
cutting operation. Debris
settles in the water tray while
the water is allowed to pass
through the tube and into the
water bucket, where fresh and
filtered water reside.
Remove the water level tube
1.
from the plastic bag.
2.
Insert the thin end of the tube
into the rear hole next to the
water pump, as shown in the
illustration.
3.
Fill the water tray with water.
WARNING:
Disconnect the water pump before attempting to handle it. Never
operate the pump without water in the tray.
10
Advertisement
Table of Contents
