Water Pump Usage Options; Overflow Plug Usage; Choosing The Right Blade - Sawmaster M1030 Owner's Manual

WATER PUMP USAGE OPTIONS

Option 1. Water pump can be placed in the top water tray
(A). (see figure 5) Only the top water tray would
need water, but care must be taken to not over fill
the tray or water will spill out from the over flow
hole on the tray.
Option 2. Water pump can be placed in the bottom water
tray (B). (see figure 5) Fill the bottom water tray
with water until water almost reaches the opening
on the over flow plug. Next fill the top water as
instructed above in "option 1".
Option 3. Water pump can be placed in a bucket (C) placed
directly below the over flow plug in the bottom
water tray. (see figure 5) Fill the bucket halfway
with water. Next fill the bottom water as instructed
above in "option 2".
WARNING:
Disconnecting the water pump should be done by a
certified electrician.

OVERFLOW PLUG USAGE

Pull the bottom water tray partially out from under the saw.
Insert the over flow plug into the hole in the tray. (see figure
6) Make sure tube is no further than 1-inch from top of tube.
See included SUPPLEMENTARY UNPACKING AND ASSEMBLY
INSTRUCTIONAL BOOKLET for more details.

CHOOSING THE RIGHT BLADE

The blade shaft speed of this saw is exclusively designed
1.
for cutting with diamond saw blades. The saw may only
be used for cutting natural and artificial stone materials,
do not cut wood or metal!
2. Choose the correct type of saw blade for the material to
be cut and the required cutting depth.
Note to dress/sharpen the blade when cutting speed is
reduced as it may lead to poor cutting accuracy. Always let
the blade cut, do not force.
Top water tray (rear section, closest to motor)
Top water tray (front section)
A
B
1-in from top of tube
Only use 10-in
blades
fi gure 5
Bottom water tray (below the frame)
C
fi gure 6
fi gure 7
8