Stryker Reprocessed Stanley Bed Alarm Sensor Pad Instructions For Use

Reprocessed for
Reprocessed Device for Single Use. Reprocessed for Stryker Sustainability Solutions.
Caution: Federal (U.S.A.) law restricts this device to sale by or on the order of a physician.
NON-STERILE NOT MADE WITH NATURAL RUBBER LATEX
Explanation of Icons
Date of Reprocessing
Use by Date
Product Code
Do Not Reuse
See Instructions For Use
Indications for Use
The Stryker Sustainability Solutions Reprocessed Stanley Bed Alarm Sensor Pads are designed to detect when the patient lifts off the
bed. These sensor pads must be connected to a compatible Stanley Bed-Check Alarm Unit.
Instructions for Use:
1. Place sensor pad on top of mattress, across the width of the bed. For best sensitivity, place the sensor pad above any pads
(exception: incontinence pad) or mattress covers. Only the bottom sheet (and incontinence pad, if used) should be between
the sensor pad and the patient.
a. Adjust sensor pad position to be under the patient's buttocks (3"-5" below mattress bend)
b. As an alternative, especially for "faster" patients, the sensor pad may be placed under the shoulder blades.
2. Secure sensor pad in position: use the enclosed rubber bands and clips, attach clips to bedsprings, frame or mattress piping.
3. Connect sensor pad to the alarm unit.
4. For continued safety, test system performance before using and daily thereafter.
5. For troubleshooting, consult the User Guide.
6. Clean by wiping sensor pad with a non-caustic sanitizing solution.
SSS •1810 West Drake Drive, Tempe, AZ 85283 USA •
K-120-F178
Instructions for Use
Reprocessed Stanley Bed Alarm Sensor Pad
www.sustainability.com
• 888-888-3433
Effective Date: 5/28/2015
SSS-HAS