Chapter 3 Configuration Settings; Bpa 600 Configuration And I/O; Bpa 600 - Update Firmware - Teledyne Lecroy Frontline BPA 600 Hardware And Software User Manual

Chapter 3 Configuration Settings

In this section the Frontline software is used to configure an analyzer for capturing data .

3.1 BPA 600 Configuration and I/O

3.1.1 BPA 600 - Update Firmware

When you select the Update Firmware on the
firmware dialog appears. You use this dialog to update your ComProbe hardware with the latest firmware.
It is very important that you update the firmware. If the firmware versions are not the same, you will not be
able to start sniffing.
1. Make sure the cabling is attached to the ComProbe hardware.
2. Select Flash Device.
The download begins, with the Status bar displaying the progress. When the download is complete,
you can check the firmware version by checking the Status dialog.
Frontline BPA 600 Hardware & Software User Manual
BPA 600 Information, the Update ComProbe BPA 600
Figure 3.1 - BPA 600 Update Firmware Dialog
16