Omron FJ-3000-10 Instruction Manual page 25

Component Names and Functions
●
LCD integrated type
Left-side view
⑥⑦ Power/
ground
terminal
① POWER LED
② RUN LED
③ ERROR LED
●
Box type
FJ-3050-10/FJ-3055-10/FJ-H3050-10/FJ-H3055-10
⑤ Camera connector
⑪ Ethernet connector
⑧ Monitor connector (analog RGB)
⑥⑦ Power/ground terminal
④ I/O connector (control lines, data lines)
① Lit while power is ON.
② Lit or turned off according to the layout under the display.
③ Lit when an error has occurred.
④ Connect the controller to external devices such as a sync sensor and PLC.
⑤ Connect cameras.
⑥ Connect a DC power supply. Wire the power supply unit independently of
other devices. After wiring, replace the terminal cover.
Power Supply and Wiring p.3
⑦ Connect the ground wire. Make sure that the controller is grounded with a
separate ground wire.
⑧ Connect a monitor.
⑨ Connect an external device such as a personal computer or PLC.
⑩ Connect a track ball, mouse and USB memory. A total of four USB ports are provided and any of them can be
used. However, when connecting two or more USB memories, do not connect them to adjacent ports. Doing so
may cause the USB memories to come into contact, resulting in malfunction or damage.
• The following items can be connected to USB ports.
• Never insert/remove USB devices during measurement. Doing so may affect measurement time.
⑪ Connect the controller to a personal computer.
⑫ A touch pen is stored. (Provided with the LCD integrated type only)
• The touch pen must be stored so that the pen tip faces to the right when viewed toward the controller.
• To remove the touch pen, push the left side (handle) of the pen to the rear. The pen's right side (pen tip) will pop out, so
hold and remove the pen.
FJ-3000-10/FJ-3005-10/FJ-H3000-10/FJ-H3005-10
Front view
⑩ USB connector
Right-side view
⑨ RS-232C/RS-422
④ I/O connector
⑧ Monitor connector
⑪ Ethernet connector
⑤ Camera connector
⑩ USB connector
⑫ Touch pen (holder)
① POWER LED
② RUN LED
③ ERROR LED
⑩ USB connector
⑨ RS-232C/RS-422 connector
Power Supply Wiring
• Commercially available track ball and mouse
connector
(control lines, data lines)
(analog RGB)
24VDC
+
–
• USB memory
8