Using The Boot Manager To Install Nokia Ipso - Nokia 500s Installation Manual

Argument
boot-device
boot-file
boot-flags

Using the Boot Manager to Install Nokia IPSO

Use the install command to install Nokia IPSO. The syntax of the command
is:
install
For complete installation procedures, see the appropriate version of release
notes.
Note
Using the install command to perform a full installation deletes the
existing IPSO image on the 500s appliance.
To install a new copy of the Nokia IPSO kernel
1. At the boot manager command prompt, enter:
2. Enter the information the install command requests (your system IP
3. Reboot the 500s appliance.
Nokia 500s Installation Guide
Default
wd0 (the hard disk drive)
/image/current/kernel
-x
BOOTMGR[0]>install
If you used the passwd command to protect this command with a
password, see "Protecting the Boot Manager with a Password"
88, the boot manager prompts you for your password before allowing you
to execute the install command.
address, the server IP address, and other information).
Using the Boot Manager to Install Nokia IPSO
on page
87