Table of Contents
Advertisement
To ground the 500s appliance
1. Locate and remove from the package the #6 ring tongue lugs and kep
2. Attach a 10 or 12 AWG insulated grounding cable to the lugs.
3. Locate the two threaded grounding studs protruding from the rear panel of
4. Slide the grounding lug loops over each of the studs.
5. Secure the grounding lugs by threading the nuts onto each of the studs
6. Attach the grounding cable to an earth ground or other grounding point to
Nokia 500s Installation Guide
nuts.
the appliance, as shown in
until they are tight. You can use an adjustable wrench or similar tool to
finish tightening the nut onto the stud. Do not over tighten the nuts.
meet the specifications of your installation site.
Figure 7
on page 29.
Before You Begin
37
Advertisement
Table of Contents
