Testing In Far End Source Mode - Fluke OF-500 OptiFiber User Manual

OF-500 OptiFiber Certifying OTDR
Users Manual

Testing in Far End Source Mode

Use Far End Source mode to measure power or power loss at
one wavelength on individual fibers. A Far End Source mode
record can store dual-wavelength results from both
directions.
A
Tester with OFTM-5611B, OFTM-5612B, OFTM-5731 or
OFTM-5732 module. Match the connector adapter to the
connectors in the link.
B
Optical source (SimpliFiber Pro source shown)
C
Memory card (optional)
D
Spare battery pack/ (optional)
78
Figure 33. Equipment for Loss Testing in Far End Source Mode
Far End Source mode requires a stand-alone optical source,
such as a Fluke Networks DTX Smart Remote with a fiber
®
module, a SimpliFiber source, or a LS-1310/1550 Laser
Source. Far End Source mode is available on OFTM-5xx1B
and OFTM-5xx2 modules. Figure 33 shows the equipment
needed for testing in Far End Source mode.
E
AC adapter with line cord (optional)
F
Two reference test cords. Match the fiber to be tested.
Match the tester, source, and link connectors as shown in
Figures 34and 35.
G
Mandrel. Recommended when testing multimode fiber.
See page 64.
H
Fiber cleaning supplies
ajt46f.eps