Schlage 7766 Installation Instructions

*77660*
77660
Surface Mount
1
Prepare frame for switch.
1a Prepare frame for surface installation of 7766 Switch.
L Note: For maximum security, it is recommended that the switch be installed in the header, 2" from the lock stile edge.
1b Wire & install switch.
2
Prepare door for magnet.
2a Install magnet.
19/32"
For LHR Door
Lock Stile
Edge of Door
#6 X 3/4" Sheet Metal
Screws - 4 Places
Check List
If switch does not work:
check recommended gap and
decrease if necessary.
7/32"
1"
1/8"
Recommended
Gap
1/2"
7766 Magnetic Door
Position Switch
Frame
1/2"
1/2"
1"
2"
3"
9/32" Dia. Through Frame for
Wiring Access on Switch
Arrow on Switch Label Must
Point Toward Door
Overhead Mounting
(See note in Step 1-A
of installation Instructions)
RHR
Shown
Arrow on Magnet Label
Must Point Toward Switch
Switch
2" Backset
Recommended
6" Maximum Backset
Lock Stile
Edge Mounting
Installation Instructions
2 13/32"
For RHR Door
Lock Stile
Edge of Door

Wiring Diagram

Yellow
Blue
SWITCH SHOWN
MAGNETICALLY ACTUATED
WARNING:
THESE ARE SIGNAL SWITCHES. NOT
INTENDED FOR DIRECT SWITCHING.
Current
Type
Rating
7766 .25 AMP
Magnet
Red