Step 6: Turn On The Groov Box; Step 7: Activate The Groov Box And Get The License File - OPTO 22 GROOV BOX User Manual

b. Connect the COM wire from the power supply (normally black) to the – (negative) terminal on
c.

Step 6: Turn on the groov Box

Briefly press and release the On/Off button. Wait until the SYS LED has stopped blinking and is solid
green. Also, take a look at the LNK ACT light for ETH0. If the cable is properly connected, the LNK ACT
light should be on or blinking.
NOTE: Always wait until the SYS LED has stopped blinking before you try to log into groov. Otherwise, you
may not be able to use the hostname to log in. If this happens, see

Step 7: Activate the groov Box and Get the License File

You'll need the activation key printed on the certificate included with your groov Box.
a. Open a web browser (Firefox or Chrome recommended). Go to activate.groov.com.
b. Log in using your email address and your My.Opto22 password.
c.
CAUTION:
Reversing wire polarity may cause damage to your groov Box. This damage is not
covered by Opto 22's warranty. If you are not certain about the polarity of the wires on your power
supply, check with a meter.
the power connector.
Connect a lead from a known earth/chassis ground to the (ground) terminal on the power
connector.
You may have set up your free My.Opto22 account when you purchased your groov Box. If you
don't have a My.Opto22 account, enter your email address and other information, and the
account will be created.
Follow the on-screen instructions to activate your groov Box and download the license file.
When asked to enter the serial number, you'll find it on the label on the top of the device.
CHAPTER 2: GETTING STARTED
page 58.
groov Box User's Guide for GROOV AT1
11
11