6. Power up the server H1 (serial number ending in "-H1") by pressing the Power
button (
FIGURE 3-24
Caution – Do not power up server H2 until directed in the instructions that follow.
7. Verify server H1 has completed booting up: the LCD should display "Quiet."
8. To complete the power up sequence, continue with the next section "Setting Up
and Configuring the System" below.
Setting Up and Configuring the System
To get the Cluster system up and running, you must specify IP addresses, basic
configuration information, and LUN ownership.
Setting IP Addresses
If your network supports DHCP, an IP address will automatically be assigned to
your LAN ports.
1. If DHCP is not available, assign a static IP address using the server H1's LCD
module:
70
Sun StorEdge 5310 NAS Appliance Hardware Installation, Configuration, and User Guide • May 2005
) on the front panel (behind the faceplate).
FIGURE 3-24
Power Button and Front Panel Detail