Tightening Torques; Cable Gland Clamping Range - ABB PVS-120-TL Quick Installation Manual

16.
Physical
Environmental Protection Rating
Cooling System
Dimensions (H x W x D)
Weight
Assembly System
Overvoltage rating as per IEC 62109-1
Safety
Safety class
Insulation Level
Marking
Safety, EMC and Radio Spectrum Standards
Grid Standards (check the availability with your sales channel)
Other Standards
Accessories
Assembly accessories
1. In the event of a fault, limited by the external protection envisaged on the AC circuit
2. Please refer to the document "String inverters – Product manual appendix" available at www.abb.com/solarinverters for information on the quick-fit connector brand and
model used in the inverter.
3. 75A 5 cycles according to standard IEC60947.3 Table D.5
4. Maximum fuse size supported 20 A. Additionally two specific string inputs per MPPT supports 30 A fuse sizes for connecting two strings per input
5. The output voltage range may vary according to the grid standard of the country of installation
6. The output frequency range may vary according to the grid standard of the country of installation
7. Only available for PVS-100-TL model.
8. Hereby, Power-One Italy S.p.A. (A Member of the ABB Group) declares that the radio equipments, to which this Quick Installation Guide refers, are in compliance with the
Directive 2014/53/EU. The full text of the EU Declaration of Conformity is available at the following internet address: www.abb.com/solarinverters.
Note. Features not specifically mentioned in this data sheet are not included in the product

Tightening torques

To maintain the IP66 protection of the system and for optimal installation, the following tightening torques must be used:
Tightening torques
Single core AC cable gland
Single core PE cable gland
Multi core AC cable gland
Multi core AC cable gland
Service cable gland M25
12
AC connection busbar
21
AC interface power connector (male)
DC interface connector (male)
Protective earth point (int.)
Protective earth point (ext.)
Junction screws
18
Side bracket screws
Interface signal connector counterparts

Cable gland clamping range

Cable gland clamping range
Single core AC cable gland
Single core PE cable gland
Multi core AC cable gland
Multi core AC cable gland
Service cable gland 12 M25
M40
11
M25
11
M63 (type 1)
11
M63 (type 2)
11
bolts
screws
24
17 screws
25 nut
10 nut
32 34 35
M40
11
M25
11
M63 (type 1)
11
M63 (type 2)
11
PVS-100-TL
IP 66 (IP54 for the cooling section)
867x1086x419 mm / 34.2"x42.7"x16.5" for -SX model
867x1086x458 mm / 34.2"x42.7"x18.0" for -SX2 model
70kg / 154 lbs for power module ;
Mounting bracket vertical & horizontal support
IEC/EN 62109-1, IEC/EN 62109-2, EN 61000-6-1, EN 61000-6-2, EN 61000-6-3,
EN 61000-6-4, EN 61000-3-11, EN 61000-3-12, EN 301 489-1, EN 301 489-17,
CEI 0-16, CEI 0-21 , IEC 61727, JORDAN IRR-DCC-MV, G59/3, VDE-AR-N 4105
(7)
DIN V VDE V 0126-1-1, EN 50438 (including Ireland national requirements), IEC 62116,
AS/NZS 4777.2, CLC-TS 50549-1, CLC-TS 50549-2, VFR 2014
UTE C 15-712-1, IEC 60068-2-1, IEC 60068-2-2, IEC 60068-2-14, IEC 60068-2-30,
IEC 60068-2-78, IEC 61683, P.O. 12.3 , ITC-BT-40
AC multicore cable gland plate (Supports M63 Ø 34...45mm + M25 Ø 10...17mm)
AC multicore cable gland plate (Supports M63 Ø 37...53mm + M25 Ø 10...17mm)
5 Nm
5 Nm
18 Nm
18 Nm
5 Nm
25 Nm
3 Nm
3 Nm
21 Nm
12 Nm
12 Nm
5 Nm
0.25 Nm
19...28mm
10...17mm
34...45mm
37...53mm
10...17mm
- 30 -
PVS-120-TL
Forced air
~55kg / 121 lbs for Wiring box
Overall max ~125 kg / 276 lbs
II (DC input) III (AC output)
I
Transformerless
CE
(8)
EN 300 328, EN 62311
PVS Installation Kit
EN
,
(7)