Omron F3SG-4RA****-25-01TS Series Quick Installation Manual page 21

Setting with DIP Switch
■
Mounting and Beam Alignment
1. Loosen the screws and adjust the angle.
Step1
Check
position
Screw (1)
(Hexagon socket head
cap screw (M4×10))
Step2
Mount
Top/Bottom
Bracket (3)
Step3
The width across flat of the hexagon socket of the Screws (1) and (2) is S=3.
Align
beams
2. Adjust the mounting position and secure the bracket.
Make sure to position the whole body of the Top/Bottom Bracket (1) within the yellow area of the housing.
<Backside mounting>
Top/Bottom
Bracket (1)
3. Secure the bracket to the wall.
Screws to mount the brackets to the wall are not included.
7
Wiring
Top/Bottom
Bracket (1)
Top/Bottom
Bracket (2)
Slide into the housing
Top/Bottom
Bracket (2)
<Backside mounting>
Mounting/Beam Alignment
Screw (2)
(Low head hexagon socket head
cap screw (M5×10))
Top/Bottom
Bracket (3)
<Side mounting>
Top/Bottom
Bracket (1)
Top/Bottom
Bracket (2)
(The recommended torque to tighten is 3.0 N•m.)
<Side mounting>
Operation check
Top/Bottom
Bracket (2)
Top/Bottom
Bracket (1)
Slide into the housing
F3SG-4RA-25-01TS
Quick Installation Manual