Samsung CLP-600 Series User Manual page 68

2
Remove the four screws on the back of the printer.
3
Remove the control board cover from the printer.
4
Remove the five screws holding the metal plate in place,
and then remove the metal cover, as shown below.
5
6
7
9.3
Installing Printer Options
To remove an existing wired network interface card,
remove the two screws and the card.
Separate the wired/wireless network card antenna from
the card itself.
Align the connector on the network interface card with the
connector on the control board. Make sure that the jacks
on the card go through the holes. Push the card firmly into
the connector on the control board until it is completely
and securely seated.