Network Menu - Samsung CLP-600 Series User Manual

Item
This item allows you to maintain the toner
cartridges and other consumables.
• Check Others: This item allows you to view
the usage status of consumables.
Items you can check:
- Fuser
- MP Pickroll, Tray1 Pickroll, Tray2 Pick
Maintenance
roll: These items are only for service
technicians.
• Alarm Shortage: This item determines how
the printer behaves when consumable items
run low.
Off: The printer does not display a warning
message.
On: The printer displays a warning message.

Network Menu

This menu lets you configure the network interface card
installed in your printer according to how the network is set up.
You can upgrade the network interface card firmware, and print
the configuration. (*: the default setting)
Item
Options: Yes, No
Sets whether or not you configure the network.
If you select Yes, you can configure the TCP/IP
Config Network
and Netware menus.
If you select Yes, the following options are
available: Config TCP, Config WLAN, and
Netware.
Options: Yes, No
Select whether you set the IP address or not.
If you select Yes, you can configure the IP
Config TCP
address.
If you select Yes, the IP Get Method option
appears on the display. You can select how to get
the IP address.
Explanation
Explanation
Using the Control Panel
Item
IP Get Method
IP Address
Subnet Mask
Gateway
Config WLAN
3.5
Explanation
Options: Static, BOOTP, DHCP
You can set this item only when you set the
Config TCP to Yes.
• Static: You can enter an IP address,
subnetmask, and gateway manually.
• BOOTP: The BOOTP server allots an IP address
to you automatically.
• DHCP: The DHCP server allots an IP address to
you automatically.
You can select this item only when you set IP
Get Method to Static. This item lets you enter
an IP address manually. Press the scroll button to
set the value of the 1st byte between 0 and 255,
and then press the Enter button.
Set the value for the 2nd, 3rd, and 4th byte the
same way.
You can set this item only when you set IP Get
Method to Static. This item lets you enter a
subnet mask manually. Press the scroll button to
set the value of the 1st byte between 0 and 255,
and then press the Enter button.
Set the value for the 2nd, 3rd, and 4th byte the
same way.
You can set this item only when you set IP Get
Method to Static. This item lets you enter a
gateway manually. Press the scroll button to set
the value of the 1st byte between 0 and 255, and
then press the Enter button.
Set the value for the 2nd, 3rd, and 4th byte the
same way.
Values: Yes, No
Configure the wireless network environments.
If you select Yes, the following options are
available: SSID, Operation Mode,
Frequency Mode, Channel, Security Mode,
Authentication, Encryption, Using Key, Key
Type, and Key1~Key4.
See "Configuring the Wireless Network" on
page 8.4
N
: This menu only appears when an optional
OTE
wired/wireless network interface card has been
installed.