How To Install Your Canopy Housing; How To Assemble Your Ceiling Fan Blades - Fanimation DUPLEX FPD6254GR Manual

NOTE: This step is applicable after the neccessary wiring
is completed.
1. Remove one of the two shoulder screws in the
hanger bracket. Loosen the second shoulder screw
without fully removing it. Assemble canopy by
rotating key slot in canopy over shoulder screw in
hanger bracket. Tighten shoulder screw. Fully
assemble and tighten second shoulder screw that
was previously removed. (Figure 1)
To avoid possible fire or shock, make sure that the
electrical wires are completely inside the canopy
housing and not pinched between the housing and the
ceiling.
2. Securely attach and tighten the canopy screw cover
over the shoulder screws in the hanger bracket utilizing
the keyslot twist-lock feature. (Figure 2)

How to Assemble Your Ceiling Fan Blades

1. Secure the blades to the motor assembly using
the 3/16˝-24 screws and fiber washers. (Figure 1)
Do not connect fan blades until the fan is completely
installed. Installing the fan with blades assembled
may result in damage to the fan blades.
NOTE:
Periodically check blade hardware and
resecure if necessary.
2. Remove six screws from the motor and retain
the screws for later. (Figure 2)

How to Install Your Canopy Housing

WARNING
CAUTION
Motor
Assembly
HARDWARE USED:
3/16˝-24
WASHER HEAD
SCREWS
FIBER WASHER
Motor Assembly
11
Ceiling Canopy
Figure 1
Canopy Screw
Cover
Figure 2
3/16˝-24 Waher Head Screw
and Fiber Washer
(3 each per blade)
Figure 1
x 6
x 6
Figure 2
Blade