Gauge (Instaset Bar) Setting - Uchida Yoko AeroCut nano+ Operation Manual

2.4 Gauge (InstaSet bar) setting

・Select the right InstaSet bar
according to desired cut pattern.
① Loosen the slitter head lock knobs.
② Slide the slitter head with holding the knob.
Adjust the positions of the slitters so that their pins fit to the U-notches on the
InstaSet bar. Snap the InstaSet bar with the labeled side on top and adjust it so that
its pointer points 0.
③ Tighten the screws.
④ Tighten the slitter head lock knobs.
・Some cut patterns do not require to use
all the slitter units.
In such cases, slide the unnecessary
slitter head(s) to side trench and tighten
the slitter head lock knob(s).
AeroCut nano+ OPERATION MANUAL
Gauge
(InstaSet bar)
Pin
Slitter head
④
Tight
Slitter head lock knob
Lock knob
10
U-notch
Pointer
Loose
①
Scale
Don't use the head
③
Screws x2
②
Gauge
(InstaSet bar)