Bosch GLM 50 C Operating/Safety Instructions Manual page 31

Memory Function
The last 30 measurements are automatically stored
(can be any type of measurement: length, area, vol-
ume, etc.). To retrieve stored measurements, press
the function button 7 [Func] and use the plus button
3 [ ] or minus button 8 [ ] to cycle through the mea-
surement functions until the highlighted square ap-
pears over the indicator for memory
"Memory" appears in the status bar. Select memory
by pressing the measure button 2 [ ]. Use the plus
button 3 [ ] or minus button 8 [ ] to scroll through
the most recent measurements.
161'00" ⁄
value in the memory is deleted.
Deleting the Memory
To delete the measurements stored in a given memory
position, simply press the Clear/ On/Off button 5 [ ]
while on the measurement you want to delete.
By simultaneously pressing the measuring reference
button 4 and the Clear/ On/Off button 5 [ ], all values
stored in memory are deleted.
2610050658 01-18 GLM50C.indd 31
Inclination measurement is used to
measure a slope or incline. The left
side of the laser measure serves as
the reference level for inclination mea-
32.0°
surement.
If there is no value yet saved to memo-
30
ry, 0'00" is shown at the bottom of the
display and "0" at the top.
The oldest value is located in position
1 in the memory, while the newest
value is in position 30 (when 30 mea-
suring values have been taken). If an
additional measurement beyond the
30th measurement is taken, the oldest
1°2°3°
-31-
and the word
1/8/18 9:54 AM