Bosch GLM 50 C Operating/Safety Instructions Manual page 30

Press the measure button 2 [ ] to go to the stake out
measurement display.
[ ] again to start the stake out measurement function.
Move the laser measure slowly from the starting point.
1.70x
number 2, then you are approaching the second set of
the pre-set measurement if you slide the laser measure
in the direction the bottom of the laser measure. If the
top arrow shows the number 2, you are moving away
from the second set of the pre-set measurement if you
slide the laser measure in the direction of the bottom
of the laser measure.
The left factor indicates how many times the defined
length has been reached. The green arrows on each
side of the display indicate the achievement of a length
for marking purpose.
Inclination Measurement / Digital spirit level
For inclination measurement/digital spirit level, press
the function button 7 [Func] and use the plus button
3 [ ] or minus button 8 [ ] to cycle through the mea-
surement functions until the highlighted square ap-
pears over the indicator for inclination measurement
Select inclination measurement by pressing the mea-
sure button 2 [ ].
2610050658 01-18 GLM50C.indd 30
The laser measure continuously mea-
sures the distance to the starting
point. The defined length and actual
Func
1.00ft
measuring value are shown in the dis-
1'08" ⅓
play. The large arrows that display at
001.00ft
the top or bottom of the screen indi-
cate the positions of the previous or
next pre-set measurement. For exam-
2
ple, if the bottom arrow shows the
and the word "Level" appears in the status bar.
There are two modes of inclination
measurement as indicated by the im-
ages to the left.
The digital spirit level is used to check
1°2°3°
horizontal or vertical alignment of an
object. If the inclination exceeds 3°,
the ball flashes in the display.
Press the measure button 2
SET
+
‒
-30-
1/8/18 9:54 AM