Bosch GLM 50 C Operating/Safety Instructions Manual page 25

tor for area measurement
pears in the status bar. Select area measurement by
pressing the measure button 2 [ ]. Activate the laser
by pressing the measure button 2 [ ]. The laser will
be switched on.
0.0°
71.917ft
lines d and the area will automatically be calculated
and display on the result line e.
Volume Measurement
For volume measurements, press the function button
7 [Func] and use the plus button 3 [ ] or minus but-
ton 8 [ ] to cycle through the measurement functions
until the highlighted square appears over the indicator
for volume measurement
appears in the status bar. Select volume measurement
by pressing the measure button 2 [ ]. Activate the
laser by pressing the measure button 2 [ ]. The laser
will be switched on.
0.0° W
456.45ft
Aim and press the measure button 2 [ ] again to take
the measurement for height which will appear on the
bottom line of the measured-value lines d and the vol-
ume will automatically be calculated and display on
the result line e.
2610050658 01-18 GLM50C.indd 25
Aim and press the measure button 2
[ ] again to take the measurement
for length which will appear on the
4'02"
⁄
L
top line of the measured-value lines
W 16'11"
d.
Aim and press the measure button 2
2
[ ] again to take the measurement
for width which will appear on the
middle line of the measured-value
Aim and press the measure button 2
[ ] again to take the measurement for
length which will appear on the top
4'02"
⁄
L
line of the measured-value lines d.
8'05"
Aim and press the measure button 2
12'08"
⁄
H
[ ] again to take the measurement for
3
width which will appear on the middle
line of the measured-value lines d.
and the word "Area" ap-
and the word "Volume"
-25-
1/8/18 9:54 AM