Uplift Desk KBT001 Instructions

Package Contents:
Track
(11'' and 21'' tracks are included)
(two stoppers come pre-installed on each track)
Mechanism
UPLIFT Desk • 1-800-349-3839 • info@upliftdesk.com • www.upliftdesk.com
Wrist support
Tray
*A note before you begin:
Determine where to mount the Keyboard tray. If you need to mount
it over the Crossbars of your desk, open the box containing the Track
Spacer Kit and follow the instructions inside.
Step 1
Take the Track and place underneath your desktop, in order to
figure out which size to use (11'' or 21'' Track) and where to place it.
If there are pre-drilled holes in your desktop, line the track up with
the holes. If there are not pre-driled holes, drill your own pilot holes
using 1/8'' diameter drill bit and drill 1/2'' deep. Be sure to leave about
1/2" from the front of the desk. Align the Track so the side with the
plastic stoppers are at the back, adn the open end pointed to the
front of the desk. Use eight (8) Wood screws to attach the 21'' track,
and six (6) Wood screws to attach the 11'' track to the desktop.
fig 1.
Caution:
When using screws on a desktop with a center-cut ergo edge, take
care to ensure that the screw is not close to the ergo edge to avoid
piercing the desktop with the screw. (see fig. 1)
Step 2
Slide the Mechanism into place on the Track.
Step 3
Insert two (2) Stoppers and two (2) Self-tapping screws into the
front of the Track to keep the Mechanism from sliding out.
There will be two more Stoppers and Self-tapping screws left over,
should you decide to use the other Track in the future.
Step 4
Secure the Tray to the Mechanism using the four (4) Machine screws,
the four (4) Washers, and the four (4) Acorn nuts.
Tighten the Acorn nuts: hold the screw still with a Philips head screw-
driver, and tighten the accompanying Acorn nut with the Flat wrench.
®
E3 Keyboard Tray
KBT001
Wood screw
(qty 8)
Stopper
(qty 4)
Self-tapping screw
(qty 4)
Allen wrench
Machine screw
(qty 4)
Washer
(qty 4)
Acorn nut
(qty 4)
Track Spacer Kit
Flat wrench
(optional)
KBT001/R02