reader mode setup
READER MODE SETUP (RF/PIN COMBINATION MODE)
No Master Card or Master PIN is ever registered.
If you remember the Master Card or the Master PIN was registered, initialize the product and try again.
1.
When you turn on the product, all of the 3 LED indicators will fl ash with a
beep.
•
No flashing of the 3 indicators denotes that the reader mode is already
specified.
0
2.
Press Button
and Button
3.
Present a card that you want to register as the Master Card to the device.
When the Master Card is registered, only the red LED indicator flashes.
4.
Present cards or PIN numbers (4-6 digits) to register with the device one
after another, and the device will register them with a beep. If you don't want
to register the cards right now, simply jump to Step 5 above without through Step 4 above.
5.
Present the registered Master Card to the product once again.
6.
The device enters Standby mode with only the orange LED indicator flashing.
ENABLING KEYPAD INPUT FOR THE CARD NUMBER
Ensure that you must have registered the Master Card.
1.
Present the Master Card to the device.
7
2.
Press Button
and Button
•
Repeat Step 1 above to release the specified mode, press Button
4
Button
in sequence, and press
M
You can set the device to allow you to control the door by entering the 8 digit
card number using the keypad.
The default is "Keypad Input Disabled".
20_ Reader Mode Setup
5
in sequence and press
ENT
or
3
in sequence and press
ENT
.
ENT
.
.
7
and