Parking Brake Button - Can-Am Spyder RT 2018 Operator's Manual

PRIMARY CONTROLS
SM6 Models and SE6 Base Model
rmo2010-001-037_a
1. Brake pedal
2. Footrest
NOTE: When riding, make sure not
to lean your foot on brake pedal. Oth-
erwise, the engine management will
activate the limp home mode to pro-
tect the braking system.
RT Limited SE6 Models
rmo2013-005-015_a
NORMAL CONDITION
1. Brake pedal
2. Floorboard
A mechanism allows the floorboard to
lower if the pedal needs to be pressed
more than normal. If that occurs, push
on the rear portion of the floorboard un-
til it clicks and test the braking system.
______________
16
rmo2013-005-016_a
LOWERED FLOORBOARD
1. Floorboard
If this condition persists or if you find
any braking system problems, refer to
an authorized Can-Am Spyder roadster
dealer.

7) Parking Brake Button

The parking brake button is located on
the LH grip. It allows to engage or re-
lease the electric parking brake.
On SE6 models, there will be a 20 sec-
ond beep sound when stopping the en-
gine while the parking brake is not en-
gaged.
219001827-006_i
1. Parking brake button
NOTE: To apply or release the parking
brake, the ignition key must be turned
ON.
NOTE: The battery voltage must be
at 11 V minimum to activate the park-
ing brake. If voltage is below 11 V, the
parking brake indicator lamp will turn
ON and the cluster will display a park-
ing brake failure message.