Control Identification - Hirschmann PAT TRS 05 / PATB3 Installation And Setup Manual

System Description
2.1.2

Control Identification

Power (red), sensor link
1-2, left to right (green)
Alarm (red), sensor battery level
1-2, left to right (yellow)
LEDS Green Heartbeat LED
(located just under radio module)
software chip
radio module 031-300-300-024
Heartbeat LED: When blinking, this small surface board mounted green LED indicates the system is
operation properly.
ID button: The red ID button, located below the software chip on the receiver board, is used to setup
the sensor transmitter to the receiver.
© Hirschmann Rev. -03/09/2006
ID button
LEDS
LEDS
5
190203_-