Weiser SmartCode 5 Installation And User Manual page 3

7
Add user codes (8 max)
Programming Timeout
If no button is pressed for five seconds, the system will time
out and you will need to restart the procedure.
A
Make sure the door is open. Press
the Program button the number of
times that corresponds to the user
code position being programmed.
Example: If
programming
the third code,
press the button
three times.
D
What lights and sounds does the lock produce?
One green flash with one beep*
green
Programming was successful.
*Beeping sound will only be heard if switch #3 (on the lock interior) is in the on positon. See "Switches and Status LED Colors" on page 4.
Mastercode
For enhanced security, a mastercode may be used when adding and deleting user codes. For more information about the mastercode, download the Programming
and Troubleshooting Guide on the SmartCode 5 Lever page at www.weiserlock.com.
8
Test the lock (review normal operation)
Confirm that the code(s) added in previous step can unlock the door.
Locking the Door
Press Lock button once.
9 Re-key the lock (if needed) and install the battery cover
A
Re-key the lock (if needed).
a
IMPORTANT:
Remove battery
pack before
K
re-keying.
B
Enter user code. A total of 8 user
codes may be programmed.
Three red flashes with three beeps*
or
1x
Make sure the user code is not a duplicate and that it is
between 4 and 8 digits during your next attempt.
Re-key the lock to work with your
c
b
existing key. See the supplied
SmartKey Re-key instructions
Reinstall
for more information.
battery
pack.
H
C
Each user code must be
a unique code between
4 and 8 digits.
or
3x
red
Programming was unsuccessful.
Unlocking the Door
Enter user code.
Tip: You can press the
Lock button before
entering your user
code to light up the
keypad at night.
B
Install the battery cover.
a
K
3 / 4
Press Lock button once.
Two beeps*
2x
Programming time out.
Make sure not to pause for more than 5
seconds during programming.
b
M
actual
size
V
V (2x)