Advertisement
How to Perform the Door Handing Process:
1
Install 4 AA batteries in battery pack.
2
Make sure the door is open. Insert the battery pack while pressing and
holding the Program button. Release the button when the battery pack is
all the way inside the lock interior.
3
The Status LED will flash red and green, and the lock will beep.
Status LED
4
Press and release the Program button again. The latch bolt will retract and
extend on its own.
5
Did the latch bolt bolt retract and extend on its own?
Door handing process
was successful! Proceed
to next step after latch
bolt stops moving.
THE LEADER IN RESIDENTIAL SECURITY
YES
NO
or
Remove battery pack,
wait 15 seconds,
then attempt the
process again.
213826 10/17
Advertisement
Table of Contents
Related Manuals for Weiser kevo Touch-to-Open
Summary of Contents for Weiser kevo Touch-to-Open
- Page 1 How to Perform the Door Handing Process: Install 4 AA batteries in battery pack. Make sure the door is open. Insert the battery pack while pressing and holding the Program button. Release the button when the battery pack is all the way inside the lock interior. The Status LED will flash red and green, and the lock will beep.
- Page 2 How to Add or Remove eKeys: If this lock was professionally installed (or installed by someone other than the homeowner), make sure that this process is performed by the homeowner. Download the Kevo app at https://www.weiserlock.com/kevo/app or scan the QR code. Follow the instructions inside the app to create an account and enroll your first smartphone.
Need help?
Do you have a question about the kevo Touch-to-Open and is the answer not in the manual?
Questions and answers