Redring R6508 Handbook page 9

How to maintain your shower (including Handset Information)
It is recommended that the shower unit, riser rail, hose etc. can be cleaned using a soft cloth
and that the use of an abrasive or solvent cleaning fluid be avoided, especially on any plated
finishes (650 chrome only).
Micro fibre clothes are recommended for cleaning the chrome (650 chrome only).
We recommend that, before cleaning, the isolating switch be turned off, thus avoiding
accidentally switching on the shower.
YOU MUST REGULARLY INSPECT THE SHOWER HOSE FOR WEAR AND DAMAGE.
REPLACE IF NECESSARY, OR EVERY TWO YEARS, WITH OUR APPROVED PART.
THIS SHOWER IS DESIGNED AND APPROVED TO EN-60335
UNDER NO CIRCUMSTANCES MUST ANY HANDSET THAT IS NOT APPROVED BY THE
IN ORDER TO MAINTAIN THE PERFORMANCE OF YOUR SHOWER,
YOU MUST REGULARLY DESCALE THE SHOWER HANDSET.
There are a number of defined spray plate settings modes (patterns) adjustable by rotating the
spray plate. The modes (patterns) have a positive "click" to identify them.
The spray plate rotates through a full circle (360°) in either direction to change the spray pattern
All water contains particles of lime-scale, which build up in the shower handset and unit
reducing the performance.
It is therefore important to regularly clean the shower handset by simply rubbing the
rubber nozzles, or soaking in proprietary lime-scale remover and rinsing thoroughly
before use.
The frequency of this will vary from weekly to quarterly depending on the
water hardness and experience.
In some winter conditions, when the incoming mains water is particularly cold it may
be necessary to select the inner or outer spray pattern only.
This will ensure correct operation of the shower with a slightly lower water flow rate.
Note: After use it is normal for some water to drip from the showerhead for a
few moments, this inhibits lime-scale build up over prolonged use.
WITH THE HANDSET PROVIDED.
MANUFACTURER BE USED WITH THIS PRODUCT.
WARNING!
WARNING!
WARNING!
9