Vehicle Tool Kit - Mercedes-Benz Marco Polo 2017 Owner's Manual Supplement

Vehicle tool kit

88
Vehicle tool kit
General notes
The vehicle tool kit is located in the stowage
compartment in the rear (see vehicle Operating
Instructions).
i To remove the vehicle tool kit, raise the bed
extension and fasten it to the head restraint
Y
( page 31).
Handle for seat sliders
When removing the seat/berth combination, a
rear bench seat or a seat, the seat sliders may be
displaced in a guide rail. The seat sliders are
then no longer parallel in the guide rails. If the
seat sliders in the guide rails are no longer in the
same position, you can no longer fit the respec-
tive seating.
Use handle : to move the seat sliders to the
correct position. In addition, you can use the
end of the handle to open and close the locks on
the sliders. The handle is in the stowage com-
partment of the seat/berth combination.
Moving the seat sliders
X
Place the tip of handle : onto the middle bolt
of the 3 bolts ?.
X
Swing handle : downwards onto seat
slider ;.
X
Press seat slider ; with handle : into guide
rail =.
Seat slider ; is unlocked.
X
Move seat slider ; into the right position and
engage.
X
Remove handle : upwards from centre
bolts ?.