Table of Contents
Advertisement
Wedge
A
Pressure regulator (30 mbar)
B
Union nut
C
Main shutoff valve
D
Gas bottle
E
X
Turn main shutoff valve D of gas cylinder E
clockwise.
X
Loosen union nut C by turning it clockwise
(left-hand thread) and remove pressure regu-
lator B from gas cylinder E.
X
Remove wedge A together with gas cylinder
E.
X
To fit: remove the protective cap or transpor-
tation lock from the gas cylinder where appli-
cable and screw on the main shutoff valve
together with the safety valve.
X
Check the forced ventilation in the gas cylin-
der container floor.
The floor ventilation must not be closed.
X
Insert gas cylinder E into the gas cylinder
container as shown in the figure.
X
Secure gas cylinder E with wedge A in the
position shown in the illustration.
i
There is a recess for the wedge in the gas
cylinder container.
X
Place pressure regulator B onto main shutoff
valve D and tighten union nut C by turning it
anti-clockwise. Make sure that the bolt con-
nection on main shutoff valve D of the gas
cylinder is tight.
X
Align cap ? of the gas cylinder container and
fit into place.
Electrical system
i
The recesses on the cover for the quick-
release fasteners have differing radii.
X
Push quick-release fasteners = down slightly
1
and turn about a
/
4
Cap ? is closed.
X
Insert intermediate floor.
X
Close wardrobe ;.
Information on the gas cooker and gas shutoff
valve can be found in the "Kitchen" chapter .
Electrical system
Voltage supply
Your vehicle has two voltage supply circuits:
12 V power supply — direct current
R
Power supply via the auxiliary battery or with
a 230 V mains connection via the battery
charger.
230 V power supply — alternating current
R
Power supply via the 230 V mains connection
from the national grid.
The starter battery and auxiliary battery are con-
nected. For this reason you can also charge the
starter battery via the battery charger.
i
Maximum charge current for charging the
starter battery: 4 A.
12 V power supply
General notes
The 12 V power supply is supplied with power by
the additional battery. The central control panel
display shows the # symbol.
If you have connected the 230 V power supply
and switched on the residual current circuit
breaker:
the additional battery is charged
R
the 12 V power supply is supplied by the bat-
R
Y
tery charger (
page 65)
of a turn clockwise.
Z
61
Hide quick links:
Advertisement
Table of Contents
