ACME LED-Exercet User Manual

User Manual

LED-Exercet
1. Safety Instruction
Please keep this User Manual for future consultation. If you sell the unit
to another user, be sure that they also receive this instruction booklet.
Unpack and check carefully there is no transportation damage before
using the unit.
Before operating, ensure that the voltage and frequency of power supply
match the power requirements of the unit.
It's important to ground the yellow/green conductor to earth in order to
avoid electric shock.
The unit must be installed in a location with adequate ventilation, at least
50cm from adjacent surfaces. Be sure that no ventilation slots are
blocked.
Disconnect mains power before replacement or servicing.
Replace only with the same type.
Make sure there are not flammable materials close to the unit while
operating, as it is fire hazard.
Use safety cable when fixes this unit.
In the event of serious operating problem, stop using the unit
immediately. Never try to repair the unit by yourself. Repair carried out
by unskilled people can lead to damage or malfunction. Please contact
the nearest authorized technical assistance center and always use the
same type spare parts.
Do not touch any wire during operation as high voltage might be causing
electric shock.
For power supply, do not connect in series much more than 20
units, use another mains supply for next 20 units.
2. Installation
You can install the unit on the truss or ceiling. Use clamps to fix the unit to
truss. Always ensure that the unit is firmly fixed to avoid vibration and
slipping while operating. Always ensure that the structure to which you are
attaching the unit is secure. Also always use a safety cable that can hold 10
times of the weight of the unit when installing the fixture.
3. Technical Specification
Gobo Wheel: 15 gobos + white
Power supply: AC 120V~50Hz 230V~60Hz
Power consumption： 31W
LED: 1 x 10 W Cool White
Dimension： 246 x 192
x162 mm
Weight： 2.8 kg