Conformity; Trademarks; General Information - ABB COM600 series User Manual

1.3.
1.4.
1.5.
8
COM600 series, Version 5.1
Modbus Serial Slave (OPC) User's Manual
be responsible or liable for any loss or damage resulting from the use of this manual or
the application of the equipment.

Conformity

This product complies with the directive of the Council of the European Communities
on the approximation of the laws of the Member States relating to electromagnetic
compatibility (EMC Directive 2004/108/EC) and concerning electrical equipment for
use within specified voltage limits (Low-voltage directive 2006/95/EC). This conformity
is the result of tests conducted by ABB in accordance with the product standards EN
50263 and EN 60255-26 for the EMC directive, and with the product standards EN
60255-1 and EN 60255-27 for the low voltage directive. The product is designed in
accordance with the international standards of the IEC 60255 series.

Trademarks

ABB is a registered trademark of ABB Group. All other brand or product names men-
tioned in this document may be trademarks or registered trademarks of their respective
holders.

General information

This manual provides thorough information on the OPC Client for Modbus Serial Slave
protocol (later referred to as Modbus Serial Slave OPC Client) and the central concepts
related to it. You find instructions on how to take it into use. The basic operation proced-
ures are also discussed.
Information in this user's manual is intended for application engineers who configure
Modbus Serial Slave OPC Client to establish data transfer between the Modbus master
system and process devices connected to COM600.
As a prerequisite, you should understand the Modbus protocol and the basic procedures
in Station Automation Builder 600 (later referred to as SAB600).
This user's manual is divided into following sections:
Introduction
This section gives an overview of the Modbus Serial Slave OPC Client and its features.
1MRS756913