Table of Contents
Advertisement
4
Installation > Installation Procedure
12)
Remove the screw securing the Left Rear Cover. (The removed screw will not be
used).
13)
Install the Left Side Rail (included in the package) by inserting the 2 pins of the Left
Side Rail in the host machine and hooking the [A] part on the hole of the plate of the rail.
• 2 Screws (Binding; M4x8) (Upper)
• 3 Screws (TP; M4x14) (Lower)
[A]
Pin
Pin
4
Installation > Installation Procedure
F-4-16
Screw (Binding; M4x8)
x5
Screw (TP; M4x14)
F-4-17
14)
Install the Buffer Pass Unit
the
[A]
CAUTION:
1. Before installing the Buffer Pass Unit, let the Harness dangle down as shown in the
figure. (This is to connect the connector at a later step.)
2. Do not touch the [C] part when holding the Buffer Pass Unit.
[B]
[A]
part
along the rail [B].
[C]
4-7
F-4-18
F-4-19
4-7
Advertisement
Table of Contents
