Jet JWL-1015 Assembly Instructions And Parts List

Stand Extension for JWL-1015/1015VS Lathes
Read and understand the entire owner's manual that accompanied your JWL-1015
lathe before attempting assembly or operation of accessories.
Inspect contents for shipping damage. Report any damage or part shortages to your distributor. Do not discard
shipping materials until accessory is set up and functioning properly.
Shipping contents
1 Cross bar
1 Tube
1 Bracket
2 Socket head button screws, 5/16x1
4 Socket head button screws, 5/16x1/2
4 Lock washers, 5/16"
8 Flat washers, 5/16"
1 Leveler with nut
2 Socket head cap screws, 5/16x1
Tools required for assembly
1/4" hex key ("Allen wrench")
9/16" (or adjustable) wrench
Assembly
(Bracketed numbers refer to index numbers in the
exploded view. Refer to documents M-719101 and
M-719102 for instructions on assembling optional
Bed Extension and Stand to lathe).
JET
427 New Sanford Road
LaVergne, Tennessee 37086
Ph.: 800-274-6848
www.jettools.com
Assembly Instructions and Parts List
Stock No. 719103
1. Install bracket [1] to tube [6] with fasteners
[2/3/4]. Tighten screws.
2. Screw leveler with nut [7/10] into bottom of
tube [6]. The leveler can be adjusted for
height, and the nut tightened up against the
tube to secure the setting.
3. Remove the right leg from your lathe.
WARNING: Use an assistant or block up the
lathe to support it during these procedures!
4. Install the leg just removed to the outer end of
the bed extension.
5. Install the middle leg beneath center of lathe
with two socket head cap screws, lock
washers, and flat washers [5/3/2], and tighten.
Adjust leveler so that it contacts the floor, and
tighten nut up against tube.
6. Secure existing cross bar to the middle leg.
7. Install new cross bar [8] between legs with four
5/16x1/2 socket head button screws [9] and
flat washers [2] and tighten.
Manual No. M-719103
Revision A1 02/2014
Copyright © 2014 JET