Rice Lake 520 Installation Manual page 85

TEST Menu
Function
A/DTST Display A/D test
Press and hold
ADOFFS A/D offset calibration (-0.5 mv/V).
Press and hold the setup switch, then press the
ADGAIN A/D gain calibration (4.5 mv/V).
Press and hold the
D/I 1 — D/I 3 Display digital inputs 1–3
Press and hold
AOUT=0 Set analog output to zero
Press and hold
AOUTFS Set analog output to full scale
Press and hold
DEFLT Default parameters
Press and hold the setup switch, then press the
parameters to factory default values. Load cells must be recalibrated before using the indicator (see
Section 4.0 on page 28);
CLR NV Clear non-volatile storage
Press and hold the setup switch, then press the
PRTCFG Print configuration
Press and hold
the DUMPALL EDP command.
80 520 Installation Manual
ENTER
key to display raw count from A/D converter.
ENTER
key to perform gain calibration.
ENTER
key to show status of DIGINx (DIx=HI or DIx=LO).
ENTER
key to set analog output to its zero value.
ENTER
key to set analog output to its full scale value.
ENTER
key to send configuration data to the serial port. This function is equivalent to using
Table 13-12. Test Menu Functions
Description
ENTER
key to perform offset calibration.
ENTER
key to reset configuration and calibration
ENTER
key to clear values stored in battery-backed SRAM.