Rice Lake 520 Installation Manual page 65

The BATCH parameter must also be set on for each batch setpoint. If the setpoint is defined but the BATCH
parameter is off, the setpoint operates as a continuous setpoint, even during batch sequences.
Kind
OFF Setpoint turned off/ignored.
GROSSSP Gross setpoint. Trips when the current gross weight matches this value.
NETSP Net setpoint. Trips when the current net weight matches this value.
+RELSP Positive relative setpoint. Trips at a specific value above the referenced setpoint.
–RELSP Negative relative setpoint. Trips at a specific value below the referenced
setpoint.
%RELSP Percent relative setpoint. Trips at a specific percentage value of the referenced
setpoint.
PAUSE Pauses the batch sequence indefinitely. Operator must activate the BATSTRT
digital input to continue processing.
DELAY Delays the batch sequence for a specified time. The length of the delay (in
tenths of a second) is specified on the Value parameter.
WAITSS Wait for standstill. Holds the batch sequence until the scale is at standstill.
COUNTER Specifies the number of consecutive batch sequences to perform. A
BATRESET needs to be sent (through either a serial command or digital input)
or a new counter value entered for COUNTER setpoint to function properly.
AUTOJOG Automatically jogs the previous filling operation.
COZ Center of zero. The digital output associated with this setpoint is activated
when the scale is at center of zero. No value is required for this setpoint.
INMOTON In motion. The digital output associated with this setpoint is activated when the
scale is not at standstill. No value is required for this setpoint.
INRANGE In range. The digital output associated with this setpoint is activated when the
scale is within capacity range. No value is required for this setpoint.
–GROSS Negative gross weight. The digital output associated with this setpoint is
activated when the gross weight reading is less than zero. No value is required
for this setpoint.
–NET Negative net weight. The digital output associated with this setpoint is activated
when the net weight reading is less than zero. No value is required for this
setpoint.
BATCHPR Batch processing signal. The digital output associated with this setpoint is
activated whenever a batch sequence is in progress. No value is required for
this setpoint.
TIMER Tracks the progress of a batch sequence based on a timer.
The timer value, specified in tenths of a second on the VALUE parameter,
determines the length of time allowed between start and end setpoints. The
indicator START and END parameters are used to specify the start and end
setpoints. If the END setpoint is not reached before the timer expires, the digital
output associated with this setpoint is activated.
60 520 Installation Manual
Description
Table 12-1. Setpoint Kinds
Batch Continuous
√ √
√ √
√ √
√ √
√ √
√
√
√
√
√
√
√
√
√
√
√
√