Normal Mode Commands - Rice Lake 520 Installation Manual

10.1.5

Normal Mode Commands

The normal mode commands (see Table 10-13) transmit data to the EDP port on demand. The SX command is
valid only in normal operating mode; all other commands are valid in either setup or normal mode.
Command
CONSNUM Set consecutive number
UID Set unit ID
SD Set date
ST Set time
SX Start EDP or PRN streaming
EX Stop EDP or PRN streaming
DX Start streaming raw A/D counts
RS Reset system
XA Transmit accumulator value
XC Transmit count
XG Transmit gross weight in displayed units
XN Transmit net weight in displayed units
XT Transmit tare weight in displayed units
XG2 Transmit gross weight in non-displayed units
XN2 Transmit net weight in non-displayed units
XT2 Transmit tare weight in non-displayed units
XE Query system error conditions
Description
Table 10-13. Normal Mode EDP Commands
Response Format
0–9 999 999
nnnnnnn (up to seven characters)
MMDDYY, DDMMYY, YYMMDD (enter using DATEFMT
specified)
hhmm (enter using 24-hour format)
OK or ?? The respective port for EDP.STREAM or
PRN.STREAM must be set to LFT or IND to use these.
—
nnnnnn UU
where nnnnnn is the weight value, UU is the units.
nnnnn
See Section 13.3 on page 66 for detailed information about
the XE command response format.
EDP Commands 53