ABB LMT100 Operation Instructions Manual page 49

L M T S E R I E S | M A G N E TO S T R I C T I V E L E V E L T R A N S M I T T E R | O I/ L M T 1 0 0/ 2 0 0 - E N R E V. B
STEP 4:
Press or to get to "Level Calibration" menu
Press "Select" to enter the menu
IMPORTANT NOTE
Calibration points menu description
1 Sensor Value label
2 Current sensor value is the raw factory level being measured
currently
3 Calibration point index (options 00 & 01)
4 Level value (LVL) or output value of the cal point
5 Sensor value (SVL) or input value of the cal point
• The scroll function accessed by pressing the
navigation between the point number "00", the Input Value
<In>, or the Output Value <Out>
• To change between points, press
highlighted or when "01" is highlighted
• To edit the input or output value of the points press the
key when <In> or <Out> are highlighted respectively
STEP 5:
Press
input value of point 00 For wet calibration the float must be at
the position where the cal Point 00 is wanted Press
capture the Current SVL and apply it to the input value of the
point
STEP 6:
Alternatively to Step 5, for dry calibration, when the float or
level cannot be moved to the desired position for point 00
press <right> to edit the input value
Press
Press
Press
value
STEP 7:
Press
Press
point 00 use the same operations as in step Step 6
key allows
when "00" is
STEP 8:
Press
Press
Repeat the operations in steps 5-7 to set the Input and Output
Values for point 01
to scroll the cursor to <In>, which corresponds to the
to scroll from one digit to another
or keys to edit each digit
to complete this operation and OK/accept the input
to scroll the cursor to <Out>
to edit the output value To edit the Output Value of
to scroll the cursor to the point selection
key to select point 01
49
to