Zoom H3-VR Quick Manual page 6

• Setting the recording mode: Rec Settings ➡ Rec Mode
This sets the file format used to record files.
Setting
FuMa
AmbiX
Ambisonics A
Stereo
Binaural
• Setting the recording format: Rec Settings ➡ Rec Format
The recording format can be selected in consideration of audio quality and file size.
Settings range from 44.1kHz/16-bit to 96kHz/24-bit.
Higher values provide higher audio quality but also have larger file sizes.
• Setting the Ambisonic monitoring mode: Input/Output ➡ Ambisonic Monitor
This sets the conversion format when outputting Ambisonic input signals from the
PHONE OUT and LINE OUT jacks.
Setting
Stereo
Binaural
HINT
Use
• Setting the low-frequency filter: Input/Output ➡ Lo Cut
This function can reduce low-frequency noise, including air-conditioning, wind and
vocal pops. This can be set from 10 to 240 Hz or Off.
• Setting the limiter: Input/Output ➡ Limiter
The limiter can prevent distortion by reducing loud input signals.
Setting
On/Off
Threshold
Attack Time
Release Time
Explanation
Record as Ambisonics B FuMa format (4-channel).
Record as Ambisonics B AmbiX format (4-channel).
Record as Ambisonics A format (4-channel).
Record as an ordinary stereo (2-channel) file.
Record as a stereo (2-channel) file that has been converted to binaural.
Explanation
The input sound is converted to ordinary stereo and output.
The input sound is converted to binaural and output.
to adjust the headphone output volume.
Explanation
This turns the limiter on and off.
The threshold for limiter operation can be set from −2 to −16 dBFS.
In a range from 1 to 4 ms, this sets the amount of time after the input
signal exceeds the threshold until compression of the output signal is
maximized.
In a range from 1 to 500 ms, this sets the amount of time after the input
signal goes below the threshold until the limiter stops compressing the
signal.
6