Adjusting Spindle Speeds - Grizzly G0694 Owner's Manual

Adjusting Spindle
Speeds
The Model G0694 has three speed ranges for
maximum turning options. These ranges are
selected by changing belt positions on the motor
and spindle pulleys (see Figure 22).
A = Low Range
100-1000 RPM
B = Mid Range
1000-2000 RPM
C = High Range
2000-3000 RPM
Figure 22. Speed ranges for each belt position.
When turning a workpiece where a lot of mate-
rial must be removed and a rough finish does not
matter, low range, which has more torque, is best.
When turning a workpiece where a clean finish is
required, and only light cuts are made, high range
is best. Mid range is a compromise between
the two ranges. Use the speed dial to adjust the
spindle speed within each range.
Always choose the correct spindle speed
for your operation. Using the wrong speed
may lead to the workpiece breaking loose
or being thrown from the lathe at a high rate
of speed, causing fatal or severe impact
injuries.
Model G0694 (Mfd. Since 03/15)
Spindle
C
B
A
Motor
Refer to the chart in Figure 23 for help choos-
ing the correct spindle speed. Note that both the
diameter of the workpiece and the type of cutting
determines the spindle speed.
Diameter Roughing
of Work- RPM
piece
Under 2" 1520
2–4" 760
4–6" 510
6–8" 380
8–10" 300
10–12" 255
12–14" 220
14–16" 190
Figure 23. Model G0694 typical spindle speed
recommendations.
To change speed ranges:
1.
DISCONNECT MACHINE FROM POWER!
2.
Remove the threaded knob and open
the upper belt access panel, as shown in
Figure 24.
Figure 24. Belt access panel removed.
General Finishing
Cutting RPM
RPM
3000 3000
1600 2480
1080 1650
810 1240
650 1000
540 830
460 710
400 620
Threaded
Knob
-25-