Sanding/Finishing
After the turning operations are complete, the
workpiece can be sanded and finished before
removing it from the lathe (see Figure 38 for an
example).
Figure 38. Typical sanding operation.
-32-
Note: Whenever sanding or finishing, move the
tool rest holder out of the way to increase per-
sonal safety and gain adequate working room.
Sandpaper
Wrapping the sandpa-
per completely around
the workpiece could pull
your hands into the mov-
ing workpiece and cause
serious
wrap sandpaper or finish-
ing materials completely
Workpiece
around the workpiece.
Model G0694 (Mfd. Since 03/15)
injury.
Never