Selecting Turning Tools - Grizzly G0694 Owner's Manual

Selecting Turning
Tools
Lathe tools come in a variety of shapes and sizes,
and usually fall into five major categories.
• Gouges—Mainly used for rough cutting,
detail cutting, and cove profiles. The rough
gouge is a hollow, double-ground tool with
a round nose, and the detail gouge is a hol-
low, double-ground tool with either a round or
pointed nose.
Figure 27. Example of a gouge.
Skew Chisel—A very versatile tool that can
•
be used for planing, squaring, V-cutting,
beading, and parting off. The skew chisel is
flat, double-ground with one side higher than
the other (usually at an angle of 20°–40°).
Figure 28. Example of a skew chisel.
Model G0694 (Mfd. Since 03/15)
Scrapers—Typically used where access for
•
other tools is limited, such as hollowing oper-
ations. This is a flat, double-ground tool that
comes in a variety of profiles (round nose,
spear point, square nose, etc.) to match
many different contours.
Figure 29. Example of a round nose scraper.
Parting Tools—Used for sizing and cut-
•
ting off work. This is a flat tool with a sharp
pointed nose that may be single- or double-
ground.
Figure 30. Example of a parting tool.
• Specialty Tools—These are the unique,
special function tools to aid in hollowing, bowl
making, cutting profiles, etc. The Swan Neck
Hollowing Tool shown on Page 34 is a good
example of a speciality tool.
-27-