Outboard Tool Rest - Grizzly G0694 Owner's Manual

Adjusting Tool Rest Height
1.
Loosen the tool rest lock handle and adjust
the angle or height of the tool rest.
2.
position the tool rest approximately
from the workpiece and approximately
above the workpiece center line (figure 14).
Workpiece
⁄ "
1 /4" 1
4
Distances
⁄ "
1 1 /8"
8
Tool Rest
figure 14. tool rest position relative to
workpiece.
3.
re-tighten the tool rest lock handle to secure
the tool rest in position.
model g0694 (mfg. since 1/09)

Outboard Tool Rest

When the workpiece is larger than 20" in diam-
⁄ " away
1
eter, mount the workpiece on the outboard side of
4
⁄ "
1
the lathe and use the outboard tool rest.
8
To use the outboard tool rest:
1.
Center Line
Levers
2.
3.
4.
While firmly holding the tool rest support rod,
loosen the lock levers shown in figure 15.
tool rest
Lock
figure 15. outboard tool rest assembly.
adjust the tool rest support rod so that it rests
firmly on the floor.
adjust the position and height of the tool rest
for your operation.
Note: As with the inboard tool rest, make sure
the outboard tool rest is approximately
away from the workpiece and approximately
⁄ " above the workpiece center line.
1
8
Firmly re-tighten all lock levers before starting
the operation.
Lock
Levers
tool rest
support
rod
⁄ "
1
4
-21-