Teknetics G2+ Owner's Manual page 6

ASSEMBLY
Forcing in MIDDLE STEM with CAM
LOCK raised may form a burr on
Caution:
cam lock. If this happens, remove
burr with knife to allow insertion.
Assemblyiseasyand
requiresnotools.
Position S-Rod upright.
1
Rotate the
LOCKING COLLAR
2
fully in the
counterclockwise
direction.
Insert your finger
inside the tube and
3
make sure the INTERNAL CAM LOCK is flush with the
inside of the tube.
Insert the MIDDLE STEM into the S-ROD,
with the SILVER BUTTON pointed upward
4
Rotate the MIDDLE STEM until the SILVER BUTTON
snaps into the hole.
5
Twist the LOCKING COLLAR fully in the clockwise direction
until it locks.
6
Repeat this process on the LOWER STEM.
7
Using the BOLT and KNURLED KNOB, attach the
SEARCHCOIL to the LOWER STEM.
8
Adjust the LOWER STEM to a length that lets you maintain a
comfortable upright posture, with your arm relaxed at your side,
9
and the SEARCHCOIL parallel to the ground in front of you.
Wind the CABLE securely around the STEMS.
10
Connect CABLE PLUG to housing.
Do not twist the Cable or Plug. Turn Locking Ring only. Use
11
minimal finger pressure to start the threads. Do not cross-
thread. When the Locking Ring is fully engaged over the
threaded connector, give it a firm turn to make sure that it is
very tight. When the Locking Ring is fully engaged over the
threaded connector, it may not cover all of the threads.
Tighten both LOCKING COLLARS.
12 Secure cable with velcro straps as shown.
13
*
Note: Very tall users can purchase the optional Extended
Lower Stem (TUBE5X), for extended reach.
6
S-ROD
S-ROD
5
LOCKING
COLLAR
S-ROD
MIDDLE STEM
MIDDLE STEM
4
2
INTERNAL
3
CAM LOCK
SILVER BUTTON
MIDDLE
4
STEM