Table of Contents
Advertisement
Step 1.
Remove the LOM-adapter air baffle by pinching the tab
server.
Step 2.
Loosen the thumbscrew that secures the LOM adapter.
Step 3.
Push the LOM adapter out of the connector on the system board.
Step 4.
Lift the LOM adapter off the server as shown.
Install a new LOM adapter. See "Install the LOM adapter" on page 70.
If you are instructed to return the old LOM adapter, follow all of the packaging instructions and use any
packaging materials that are provided.
Install the LOM adapter
Use this information to install the LOM adapter.
"Read the
installation
Guidelines" on
page 41
Before installing the LOM adapter:
1. If the server comes with a LOM adapter slot bracket, remove it with a tool first. Store the bracket in case
that you later remove the LOM adapter and need the bracket to cover the place.
CAUTION:
Use a tool to remove the LOM adapter slot bracket to avoid injury.
2. Touch the static-protective package that contains the new LOM adapter to any unpainted surface on the
outside of the server. Then, take the new LOM adapter out of the package and place it on a static-
protective surface.
To install the LOM adapter, complete the following steps:
Figure 33. LOM adapter installation
Step 1.
Place the LOM adapter into the connector at an angle.
Step 2.
Rotate the LOM adapter down.
Step 3.
Push the LOM adapter as shown to insert it into the connector on the system board.
Step 4.
Tighten the thumbscrew to secure the LOM adapter.
70
User Guide forThinkAgile HX1521-R Node ThinkAgile HX3521-G NodeThinkAgile HX5521 NodeThinkAgile HX5521-C
NodeThinkAgile HX7521 Node
1
and then lifting the air baffle out of the
"Power off
the server
for this task"
on page 33
"ATTENTION:
Static Sensitive Device
Ground package before opening"
on page 43
Hide quick links:
Advertisement
Table of Contents
