Table of Contents
Advertisement
Figure 18. 2.5-inch hot-swap drive installation
Figure 19. 3.5-inch hot-swap drive installation
a.
Ensure that the drive tray handle is in the open position. Slide the drive into the drive bay until it
snaps into position.
b.
Close the drive tray handle to lock the drive in place.
Step 2.
Bring the data drive online by using the procedure
Hardware Replacement Documentation.
Step 3.
To replace a failed metadata drive, use the
Replacement Documentation.
Step 4.
Check the drive status LED to verify that the drive is operating correctly.
• If the yellow drive status LED is lit continuously, that drive is faulty and must be replaced.
• If the green drive activity LED is flashing, the drive is being accessed.
Completing Drive Replacement
in the Nutanix Hardware
Failed drive procedure
.
Chapter 8
Hardware replacement procedures
in the Nutanix
49
Hide quick links:
Advertisement
Table of Contents
