Table of Contents
Advertisement
To remove a hot-swap power supply, complete the following steps:
Step 1.
If the server is in a rack, adjust the cable management arm (CMA) to gain access to the power
supply bay.
If you have installed the 2U CMA Upgrade Kit for Toolless Slide Rail or Toolless Slide Rail Kit with
2U CMA, do the following:
Figure 21. CMA adjustment
a.
Press down the stop bracket
b.
Rotate the CMA out of the way to gain access to the power supply.
Step 2.
Disconnect the power cord from the hot-swap power supply.
Note: If you are replacing two power supplies, do the power supply replacement one by one to
ensure that the power supply to the server is not interrupted. Do not disconnect the power cord
from the secondly replaced power supply until the power output LED for the firstly replaced power
supply is lit. For the location of the power output LED, refer to "Rear view LEDs" on page 17.
54
User Guide forThinkAgile HX1521-R Node ThinkAgile HX3521-G NodeThinkAgile HX5521 NodeThinkAgile HX5521-C
NodeThinkAgile HX7521 Node
1
and rotate it to the open position.
Hide quick links:
Advertisement
Table of Contents
