Installing The Retrofit Wiring Harness On Lhd Cars - BMW 11 12 2 157 664 Installation Instructions Manual

8. 8.

Installing the retrofit wiring harness on LHD cars

Installing the retrofit wiring harness on LHD cars
A6-A10
X175
A2
BB
X18336
BA4
BA3
A5
BA1-BA2
© BMW AG, Munich.
A3-A5
X2219
A1
1
090 1456 Z
BA1-BA2
090 1488 Z
X60101
A3
A4
P
090 1489 Z
01 29 2 160 471
Screw branch A1 on B+ support point X2219 from the
top or bottom.
Screw branch A2 onto earth pins X175.
Route branches A6 – A10 to the right-hand rear side
panel.
Route branches A3 – A5 through the rubber grommet (1)
into the E-box.
Cars built before 3/07 only
Connect branch BA3 and BA4 using insulation-piercing
connector BB as follows to the cables of plug X18336,
SW 4-pin, of the glovebox light:
- Branch BA3, BR cable, to PIN 4 (BR cable)
- Branch BA4, RT/GN cable, to cable in PIN 1
(RT/GE cable)
Route branches BA1 and BA2 into the E-Box.
Push shrink tubing P over branches A3, BR cable,
and A4, RT/GN cable.
Crimp branches BA1 and BA2 to the same colours
of branches A3 and A4.
Insulate the connections with shrink tubing P.
Disconnect SW/BL cable from PIN 8 of plug X60101
(GR 26-pin) on the DME control unit, insulate it and
tie it back.
Connect branch A5, SW/BL cable, to PIN 8 of
plug X60101.
2/2011 (Z/Z) 15