The flow meter has optional pulse and 4-20mA outputs available. The 4-20mA output requires the optional DC power input which uses the battery as a backup power source. All Dura Mag flow meters have an internal datalogger standard, the optional datalogger software and cable is required to retrieve the stored data.
5.1.4 Grounding and Gaskets All Dura Mag flow meter installations require minimum grounding with a 12-gauge ground wire to an earth ground. Installation must conform to NEC requirements as described in section 5.4, which shows grounding for meters with minimal grounding noise. Flanges on the Dura Mag sensor have a non-conductive coating and may not require grounding rings.
Obstructions can include elbows, valves, pumps, and changes in pipe diameter. The uneven flow created by these obstructions can vary with each system. • Upstream Requirement: Dura Mag meters should be installed a minimum of two diameters away from of most obstructions. •...
The flow meter comes pre-configured from the factory based on the installation parameters provided to McCrometer at the time of order. Other than activating the display, there is nothing required of the user for the basic operation of the flow meter.
* All Dura Mag meters are calibrated in a NIST traceable gravimetric test stand with a minimum straight run of 10D upstream and 2D downstream. A calibration certification report is provided with each Dura Mag meter certifying the specification accuracy in our laboratory test.
Page 23
OTHER McCROMETER PRODUCTS INCLUDE: Propeller Flowmeters Di erential Pressure Flowmeters Magnetic Flowmeters ™ Wireless Monitoring System FlowConnect ™...
Need help?
Do you have a question about the Dura Mag and is the answer not in the manual?
Questions and answers